Logging Oct 10-24 on 10/11 trail
Note from Nick: We are currently logging off the eastern portion of the 10-11 trail. Work should be completed in two weeks.
Larose Forest trail reports
Note from Nick: We are currently logging off the eastern portion of the 10-11 trail. Work should be completed in two weeks.
Short skijor on the Gun Club loop around 9 this morning. Temperature was around -3 so trails were still a little hard but still softer than yesterday. One spot of bare ground about halfway on the north side that cannot be avoided – I had to stop and take off…
Skijored this morning around 9am on Moose, Concession. 10, the 10/11 trail, JGL to Broken Ski Pass, and 4th Trail across to Parking Lot Bypass. Temperature was -6 and windy, so trails were a little hard and icy and it was difficult to do anything on skis except double pole.…
Hello guys: Logging is done, sorry for the inconvenience. Moose is cleaned up and groomed. All your trails are in good shape. Enjoy!! – Nick
Eastern trails are groomed with the 10th conc to get to the south entrance of gun club. 10-11 and the deep ravine are also done. We will fix moose for the week end but its not usable right now. – Nick
Despite warm conditions and sticky snow, I was able to groom western trails today. I did not groom the big gully cause I thought I might get stuck… Conditions are pretty good but there are some ruts from a sled that ran yesterday that I wasn’t able to erase everywhere. Enjoy! – Steve
There have been horses all the way down Concession 11, so deep prints on the east side – problematic if one wants to turn east on any of the trails (Bypass. 10-11, Malamute). With the new snow you may not see them, but they could cause you trouble so keep your…
All western trails are done including deep ravine. – Nick
Went out this morning for a ski and trails (on the western side) were in very good condition with last night’s snowfall on top of a hard and groomed base. Although the mild temps and fresh snow made the snow a bit sticky and the glide was therefore not great…